ElectrotorSloMo_Hub

Electrotor-SloMo ~ Rotorhead - Hub-B

Overview:

Pitch bearing are mounted above the electric motor and rotor hubs are 15 "between centers.

Small diameter or large diameter mast.

Pitch change or Twist change.

With modifications it may be possible to implement internal electrical synchronization. Or, it should be possible to implement external mechanical and/or electrical synchronization.

Picture:

The frame underneath the rotorhubs is for the wider Hub-A

Pros & Cons:

Pros;

Close centers for synchronization, perhaps

Cons;

Working Papers:

DESIGN:

B627

MAKE:

B628

Items:

DESIGN:

	Name	Item
	_____________ Links to relevant pages on Hub-A ____________
	DESIGN: Electrotor-SloMo - Rotorhead - Hub-A - Torque Calculations	1935
	DESIGN: Electrotor-SloMo - Rotorhead - Hub-A - Blade Generated Forces - Preliminary	1936
	DESIGN: Electrotor-SloMo - Rotorhead - Hub-A - Elastomeric Rotor-to-Rotor	1940
	_____________ Hub-B ____________
	DESIGN: Electrotor-SloMo - Rotorhead - Hub-B - Developmental Drawing	1900
	DESIGN: Electrotor-SloMo - Rotorhead - Hub-B - Overview & Layout	1526
	DESIGN: Electrotor-SloMo - Rotorhead - Hub-B - Clearances - Intermeshing Configuration	2030
	DESIGN: Electrotor-SloMo - Rotorhead - Hub-B - Bearing Selection - AeroRotor to Stator	2043
	DESIGN: Electrotor-SloMo - Rotorhead - Hub-B - Bearing Selection - Blade to AeroRotor	2044
See;	DESIGN: Motor - Radial Flux - Rotor (Armature) - Bearing - Rotor-to-Rotor	2028

MAKE:

Name	Drawing	BOM
MAKE:~ Electrotor-SloMo ~ Rotorhead - Hub-B - Assembly	2029.dwg	2029
MAKE:~ Electrotor-SloMo ~ Rotorhead - Hub-B - Hub	2036.dwg
MAKE:~ Electrotor-SloMo ~ Rotorhead - Hub-B - Torque Reactor Spring	2050.dwg
MAKE:~ Electrotor-SloMo ~ Rotorhead - Hub-B - Mast Obsolete	2037.dwg
MAKE:~ Electrotor-SloMo ~ Rotorhead - Hub-B - Lower Disk	2038.dwg
MAKE:~ Electrotor-SloMo ~ Rotorhead - Hub-B - Pitch Arm - Taper Pin	2039.dwg
MAKE:~ Electrotor-SloMo ~ Rotorhead - Hub-B - Pitch Arm - Flanged Obsolete	2040.dwg

Relevant Page: ~ OTHER: Composite

Last Revised: June 7, 2011