• Cable:
• Red, Black, & White? ??AWG
• Connector:
• 3-wire, AC Chassis Mounted Socket Receptacle ~ 15A/250VAC UL / CSA [MODE 31-045-1]

• From 48VDC Power source.
• Cable:
• Red, Black, ??AWG
• Connector:
• Jones plug P304CCT-P, 4-pin plug (inline) w/ cable clamp ~ from RP electronics
• Jones plug S304AB-P, 4-pin jack (chassis mount) ~ from RP electronics
• Note that the current connection has the Male plug on the cable from the power-supply and the female in the controller's case. This means that the pins might pull out of the controller and be live. A case mounted Male Jones plug is not made. Change to another make.

• Cables:
• Maximum of 6 cables, with 2 or 3 wires each. Red, Black & White?
• Note that the cables will reduce the voltage at the motors slightly.
• Connectors:
• Present connectors at both end of cable; 3-position .093" Wire Connector, 18-22AWG MODE 37-503-1, They appear to be identical to the Molex .093" series. Note that both say #22 through #18 AWG, however, an identical connector that came with the battery charger and the wires in it are 16 GA.
• Now: 3-pin 600V 5A AC connectors;
• Bought 12 only female cable mount (plug) from Lee's Electronics. There number 216. MODE Inline plug 25-723-0/1
• Bought 10 only male chassis mount (jack) from Lee's Electronics. There number 217. MODE Inline plug 25-733-0/1
• I would have been nice to have put females in the controller chassis, where the power comes from, but chassis plugs are not sold.
• Grounding: -> 3rd wire or shielded cable ????

• Cables:
• RS232 Straight Thru Serial Cable, with DB-9 terminals. Male on controller end and female on workbench end Have 3 only 15 ft and 1 only 25 ft Computer Cable by StarTech.com, bought from Active.
• Connectors:
• Controller: 6 only DB-9 Female. MODE 9-position Right Angle PC Mount Female D-Sub # 30-420-1 or 0, bought from Active.
• Electrical Control Box at the specific Axis: DB-9 Male. MODE 9-position Right Angle PC Mount Male D-Sub # 30-410-1 or 0, bought from Active.
• 

• See ArtSoft, Mach2, Section 12-1.
• Maximum of ? cables, with 2 wires each.

• See ArtSoft, Mach2, Section 12-1.
• Maximum of ? cables, with 2 wires each.

• Emergency stop.pdf Basic emergency stop and limit switch circuit to work with Mach2
• See ArtSoft, Mach2, Section 12-1.
• See page A54 in Parker - Motion & Control web page.
• Maximum of ? cables, with 2 wires each.

Back to top | UniCopter Home Page | SynchroLite Home Page | Nemesis Home Page