CNC_0073

OTHER: CNC Work Station - Controller - Case

Electrics:

Definitions & Algorithms

Symbols

Have:

17" wide * 11.5" deep * 7" high

Suppliers:
What is the maximum electrical power I can get from 1 or 2 household circuits? What is the input for 110V / 1 phase / 60 cycle and for 220V / 1 phase / 60 cycle ????

Camtronics Inc.'s new site; http://www.camtronics-cnc.com/

Camtronics Inc.'s old site; http://www.seanet.com/~dmauch/

http://www.ktmarketing.com/CamtronicsServoCase.htm

HP PC Case?:

The Camtronic's case is 13" wide * 11" deep * 6" high, (scaled from drawing that shows 2.5" Gecko)

The old HP computer case is 14.5" deep * ' 13" wide * 3.25" high.

CNC4PC's Mini Power Supply is 2.6" from the board to the top of the transformer, therefore it will fit inside the old HP. The main power supply could be a separate unit. The area of the HP is greater than the Camtronic's, which has its power supply inside.

Drawing of CNC4PC Boards and Geckos Laid Out in HP PC Case:
Draw shows sizes but not final locations.

Fuses, fans wiring, connections, switches and lights must be added.

An AC Solid State Relay Board and an Index Pulse Card may be added.

The following drawing is now wrong.

Improvements to Consider Doing:

Swap the 110VAC and the 48VDC sockets at the rear of the case. Reason ~ To shorten the wire paths inside the case.

Put shrink tubes over 110VAC and 45VDC bare connections.

Terminals ~ To & From Case:

See: OTHER: CNC Work Station - Controller - Cables & Connectors, Etc.

Back to top | UniCopter Home Page | SynchroLite Home Page

Last Revised: May 22, 2007