CNC_0018
BUY: Shop Equipment -
CNC - Workstation - Servomotor w/o Encoder w/ Gearbox
Usage:
There are two of them
There is no use for them, at present,
Information:
Purchased on ebay
Servomotor:
- 2 only Gearmotors
- Japan Servo Company
- 24 VDC
- The spec on the actual motor and reducer show;
. No.2227
Motor shows 371 rpm
Gear ratio 1 : 12.5
6H12.5F-H58
The specs on DME60B6HFPB on page #31 show;
- A rated speed of 344 rpm and
- A torque of 74.99 oz-in [0.53 N-m]
- An output shaft of 7mm dia.
No Encoder:
- There is provision (shaft) for encoder.
Gearbox:
- 12.5:1 ratio. Parallel shafts.
Additional Material:
- There is a spec page on a very similar DME60 motor and gearbox in the front pocket of the [Electrical] binder.
- I ran the motor with a voltage of 11.88 V and no load. The current was 0.39 A and the speed was approximately 180 RPM.
- I ran the motor with a voltage of 24.8 V and no load. The current was 0.38 A and the speed was not checked.
- The stated speed of the motor at 24V is 4300 and the out put is 26W, therefore with the 12.5 ratio the output speed will be 344 rpm.
______________________________
- See the section 'USING THE G340 WITH VERY SMALL MOTORS' on page 5 of the Gecko manual. This motor might require inductors and capacitor.
Back to top | UniCopter Home Page | SynchroLite Home Page | Nemesis Home Page
Last Revised: January 5, 2007