Item 1711
DESIGN:
AeroVantage ~ PropRotor - Hub - 
.1x2 
- Layout w/ Hollow Shaft Motor
This may not offer any meaningful advantages.
Notes:
This page represents a rotor hub that utilizes a custom hollow shaft motor.
The control rods go through this hollow shaft and into the rotor-cone.
The hub can have a planetary reduction or be a direct drive from the motor.
The swashplate can be located in the rotor-cone with 3 control rods passing through the motor, or it can be a design like the Mini 500 with 3 rods (1 for each blade) passing through the motor.
In all cases the actuators will be located at the back of the motor.
Possible Combinations:
|
|
|
Direct drive: |
Planetary gears: |
|
|
Swashplate in rotor cone: |
|
|
|
|
Swashplate back of engine: |
|
|
- Currently, there are stock hollow shaft motors available for 1/4 and 1/8 or 1/12 scale craft
Drawing:
There is the crude start of a drawing.
Introduction Page | SynchroLite Home Page | Electrotor Home Page | UniCopter Home Page | Nemesis Home Page | AeroVantage Home Page:
Last Revised: September 6, 2009