Item 1453
MAKE: Special Tool ~
Rotor - Blade - Spar Root Holder
Drawing:
Note:
The step in the holder is to allow the tow to be wrapped around the pins.
Thought:
- Perhaps the root and the tip holder should be one piece.
- It will serve as the male part of the mold during cure.
- There will be no need to have tension along the X-axis. In addition, the clamping of the tip, by the female molds will 'stretch' the tow slightly.
- There will probably be no need for two A-axis motors or x-shaft, at least not for the spar.
Revised Tool:
June 23, 2005
Back to top | SynchroLite Home Page | UniCopter Home Page
Last Revised: June 23, 2005